Basement Waterproofing

Basement Waterproofing FAQs

Straight answers to the questions we're asked most.

How much does basement waterproofing cost in the UK?

Most UK basement waterproofing jobs cost £90–£160 per square metre for a cavity drain membrane, or £70–£130 per square metre for tanking. A typical small cellar made fully habitable with a membrane, sump pump and boarding comes to around £8,000–£18,000. Larger basements, poor access and pumped drainage push costs up. A survey gives you a fixed figure.

Is tanking or a cavity membrane better for a basement?

A cavity drain membrane is usually better for older cellars, because it manages water rather than trying to block it and copes with building movement. Tanking bonds directly to the wall, so any crack can let water through, and it is best where water pressure is low. Many specialists combine the two, and BS 8102 recommends considering combined protection for habitable spaces.

Do I need planning permission to waterproof a cellar?

Waterproofing an existing cellar does not normally need planning permission. Converting it into a habitable room does need Building Regulations approval, and digging out to create a new basement or lowering the floor may need planning permission and party wall notices. Listed buildings need listed building consent for most changes, so check with your council before work starts.

How long does basement waterproofing take?

A typical cellar of 20 to 30 square metres takes about one to two weeks to waterproof, including stripping old finishes, fitting the membrane, cutting perimeter channels and installing a sump. Tanking needs extra drying time before plastering. A full conversion with insulation, electrics and decoration usually runs three to six weeks from start to finish.

What is BS 8102?

BS 8102 is the British Standard code of practice for protecting below-ground structures against water from the ground. It describes three types of protection, barrier, structurally integral and drained, and three grades of dryness depending on use. Designers use it to choose the right system, and building control, warranty providers and lenders often expect basement work to follow it.

Why is my cellar damp?

Cellars are damp because their walls sit in wet ground and water moves through brick, stone and mortar by pressure and capillary action. Other common causes are leaking drains, high outside ground levels, blocked air bricks, faulty downpipes and condensation from poor ventilation. A survey separates these, because fixing a leaking gutter can be cheaper than waterproofing the whole room.

Does a cavity drain membrane need a sump pump?

A cavity drain membrane needs somewhere for the collected water to go, which is usually a sump pump. If the basement floor sits above a nearby drain or the ground falls away, gravity drainage to outside may be possible instead. Where a pump is used, twin pumps, a high-level alarm and battery backup are strongly advised to cover pump failure and power cuts.

Can you waterproof a basement from the inside?

Yes, nearly all UK basement waterproofing is done from the inside, because digging out around the outside of a terraced house is usually impossible. Internal cavity drain membranes and tanking are designed for this. External waterproofing is mainly used on new builds, where membranes can be applied to the outside of walls before backfilling.

Will waterproofing stop condensation in my basement?

Waterproofing stops water coming through the walls and floor, but it does not stop condensation on its own. Cold basement air holds moisture from people, laundry and cooking, so habitable basements also need insulation, heating and ventilation such as a mechanical extract fan or a positive input unit. Your specialist should consider all three when designing a Grade 3 space.

How long does basement waterproofing last?

A well-designed cavity drain membrane can last for decades, because the plastic membrane itself does not degrade underground. The weak points are pumps and drainage channels, which need annual servicing. Tanking can last a long time but may crack if the building moves. Keeping system drawings and service records also helps when you come to sell.

Can I put screws or shelves into a waterproofed wall?

You can fix into a membrane system once it has been boarded or battened, because fixings go into the lining, not through the membrane. Tanked walls must not be drilled after waterproofing unless the hole is resealed with a compatible product. Plan shelving, sockets and radiators with your specialist so fixing points can be built in.

Is basement waterproofing worth it?

For many terraced and semi-detached homes, waterproofing a cellar is one of the cheapest ways to gain usable floor space, because the walls and ceiling already exist. It also protects stored belongings and the timber floor above from damp. Whether it is worth it depends on cost per square metre versus local property values, which your specialist can talk through.

Get a free basement waterproofing quote

Tell us what you need and we'll come back with a clear price.

Request a quote